進口SMC脈沖式油霧器,SMC脈沖式油霧器原理
不給油潤滑:采用橡膠材料作為滑動部位的密封件,
密封件帶有滯留槽結構內存潤滑脂來潤滑。
噴油潤滑:有油霧器和集中潤滑元件兩種。
Intermittent discharge of small,
constant amounts to the sliding
parts
Directly supplies a constant
amount of oil just before the
lubrication point
進口SMC脈沖式油霧器,SMC脈沖式油霧器原理
注意事項:
1、不給油潤滑元件也可給油潤滑,旦給油,中途不得停止供油。
2、不要使用錠子油和機油,以免使密封件膨脹。
. Mount the air pipes after sufficiently flushing
them.
2. When screwing in pipes or fittings, be careful
to avoid letting cutting chips from pipe screws,
sealant, etc. get mixed in.
When wrapping with pipe tape, be sure to leave
about two threads remaining unwrapped.
趨勢:
不給油潤滑已很普遍,而給油潤滑逐漸減少。
將潤滑油進行霧化并注入空氣流中,